solenoid for hydraulics from China manufacturer - Ningbo Yinzhou Tongli Hydraulic Electrical Factory

Place of Origin:

Zhejiang, China (Mainland)


	Add to My Favorites
HiSupplier Escrow	Share \|

Product Detail

Model No.: MFZ10A-YC/MFJ10A-YC

DC:MFZ10-YC series of hydraulic solenoids apply to circuit of single-phase bridge type full-wave rectifier,voltage up to 220V.
AC:MFJ10-YC series of

Application:
DC:MFZ10-YC series of hydraulic solenoids apply to circuit of single-phase bridge type full-wave rectifier,voltage up to 220V.
AC:MFJ10-YC series of hydraulic solenoids apply to control circuit of AC 50Hz,voltage up to 380V.being used as power unit of hydraulic directional control valves.They can form a complete set of Germany REXROTH,6,10 DN threaded hydraulic directional control valves.
*When the power is AC.The user can choose MFB10YC AC hydraulic solenoids,whose performance is completely the same as MFZ10-YC.

Specifications

Model \ Parameter	Rated Voltage (V)	Rated suction (N)	Rated travel (mm)	Full Stroke (mm)	Power consumption (W)	To withstand hydraulic (MPa)	Operating frequency (T / h)
MFJ10A-27YC	110 220	≥27	3	≥6.2	28	21	12000
MFJ10A-54YC	110 220	≥54	4	≥8.5	41	21	12000
MFZ10A-37YC	12 24	≥37	3	≥6.2	30	21	12000
MFZ10A-90YC	12 24	≥90	4	≥8.5	36	21	12000

External Shape and Installing Dimension

Note:
·Solenoid wiring uses terminal box that its voltage specification shall be consistent with the solenoid's voltage specifications.
· The manual jogger of the electromagnet should be controlled by hand only in the debugging or critical situation. However, when the backing pressure of the system is pretty high and difficult to adjust, the user should use the cross head driver to slowly push the manual jogger instead of using impact force so as to avoid destroying the manual jogger and the surface of the direction hole which will cause the electromagnet to leak the oil and unable to reset.
· When the electromagnet is used Bi-direction, it should be insured that the two electromagnets cannot be electrified at the same time so as to avoid the malfunction of the electromagnet.
· Overcurrent protection system should be used in the connection part between electric control system and electromagnet so as avoid burning the electromagnet and electronic control units under improper condition.